www.desatech.com
111160-01C 19
INSTALLATION
Continued
Single Burner Seasonal Oak Models
CRL2718P/N, CRL2718P/N
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
The Seasonal Oak Log Set is a reversible log set.
This means that the two bottom logs may be turned
to face either direction. The top log, however, must
remain in the same position. Do not modify logs.
Only use logs supplied with heater.
1. Place the back log onto the back of the base
assembly. Make sure log sits forward against
the two posts in front of log (see Figure 32).
This log may be turned to face either direction.
2. Place front log onto grate on front of base as-
sembly. The log will fit down between grate
fingers and posts on front of base assembly
(see Figure 33). This log may be turned to face
either direction.
3. Place the crossover log on top of the back log
and front log making sure pins are inserted into
holes on top of logs 1 and 2 (see Figure 34).
This log must be placed as shown in Figure 34
or the pins will not seat into holes.
4. Add lava rock around base of heater if desired.
Do not put lava rock on logs or burner.
Figure 32 - Installing Back Log
Figure 33 - Installing Front Log
Front Log
Grate
Fingers
Figure 34 - Installing Crossover Log
Back Log
Post
Post
Post
Base
Assembly
Post
Base
Assembly
Crossover Log
Hole in
Back Log
Hole in
Front Log