Desa CGD3924NRA Electric Heater User Manual


 
15
107553
OWNER’S MANUAL
For more information, visit www.desatech.com
1. STOP! Read the safety information
in column 2.
2. Make sure equipment shutoff valve
is fully open.
3. Set selector switch in the OFF position.
WARNING: If you do not fol-
low these instructions exactly, a
fire or explosion may result caus-
ing property damage, personal
injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all
around the appliance area for gas. Be
sure to smell next to the floor because
some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL
GAS
Do not try to light any appliance.
Do not touch any electric switch; do
not use any phone in your building.
Immediately call your gas supplier
from a neighbor’s phone. Follow
the gas supplier’s instructions.
If you cannot reach your gas sup-
plier, call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn
by hand, don’t try to repair it, call a
qualified service technician or gas
supplier. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part
of the control system and any gas con-
trol which has been under water.
WARNING:
If fireplace has glass doors,
never operate this heater with
glass doors closed. If you oper-
ate heater with doors closed,
heat buildup inside fireplace will
cause glass to burst. Also if
fireplace opening has vents at
the bottom, you must open the
vents before operating heater.
You must operate this heater
with a fireplace screen in place.
Make sure fireplace screen is
closed before running heater.
NOTICE: During initial operation
of new heater, burning logs will
give off a paper-burning smell.
Orange flame will also be present.
Open damper or window to vent
smell. This will only last a few hours.
OPERATING
HEATER
Continued
FOR YOUR SAFETY
READ BEFORE
LIGHTING
LIGHTING
INSTRUCTIONS
WARNING: Damper handle
will be hot if heater has been
running.
Figure 34 - Control Knob and Ignitor Button Location
O
F
F
P
I
L
O
T
O
N
L
O
I
H
REMOTE
OFF
ON
Control Knob
Ignitor Button
Selector Switch in OFF Position
Flame Adjustment Knob
Note:
Home owners generally prefer to
operate their heater with the chimney
damper closed. This will put all the heat
into the room. However, there may be
times you will desire the full flames of the
HI heat setting but will find the heat out-
put excessive. You can open the chimney
damper (if you have one) fully or partially
to release some of the heat.
Figure 33 - Installing Crossover Log (#7)
to Model CCL3930NR Only
Figure 30 - Installing Crossover Log (#5)
(CCL3930NR Shown)
Figure 32 - Installing Crossover Log (#6)
(CCL3930NR Shown)
INSTALLATION
Continued
Crossover
Log (#6)
A
U
T
O
O
F
F
O
N
7
Middle
Log (#2)
Pegs
Holes
A
U
T
O
O
F
F
O
N
6
Pegs
Log #2
Front Log (#1)
Figure 31 - Installing Crossover Log (#5)
(CCL3018NR Only)
Crossover
Log (#4)
Front
Log (#1)
A
U
T
O
O
F
F
O
N
Crossover Log (#4)
Front Log (#1)