Filter
Top Products
www.desatech.com
113897-01C
19
INSTALLATION
Continued
Front
Back
Figure 29 - Installing Remote Receiver
Insulating Washers
Mounting
Clips
Figure 30 - Connecting Wires
White Wire
From Receiver
Remote
Receiver
Back
Red Wire From
Receiver
Valve
Front
4. Install remote receiver unit onto gas log heater
base using clips (2) and insulating washers
provided.
5. Push clips firmly into place (see Figure 29).
6. Connect wires as shown in Figure 30.
INSTALLING WIRELESS REMOTE
CONTROL ACCESSORY
Two 9-volt alkaline batteries (not included) are
required to operate this heater with the wireless
hand held remote control set. One battery must
be installed in the receiver and one in the hand-
held remote control unit.
Note: Only use alkaline
batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver under front burner of
heater.
2. Locate the battery clip mounted on the back
of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Installing 9-Volt Battery (Not Included) in
Hand-Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery. Place
battery into the battery housing.
3. Replace battery cover onto remote control
unit.
Figure 31 - Installing Receiver on the
Back of the Base
Battery Clip
9-Volt
Battery
Receiver
Terminal
Wires
Figure 32 - Installing Battery in Hand-Held
Remote Control Unit (CGHRCB Series)
Battery
Cover
9-Volt
Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
Figure 33 - Installing Battery in Hand-Held
Remote Control Unit (CGHRCTB Series)
9-Volt
Battery
Remote
Control
Unit
Battery
Cover
Terminal
Wires