Filter
Top Products
6
099618
These models are furnished with wheels and a front handle. Some models are
furnished with a rear handle also. Wheels, handle(s), and the mounting hardware is
found in the shipping carton.
Tools Needed
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support frame. Install wheels on axle.
IMPORTANT:
Place extended hub of wheel toward wheel support frame.
2. Place cap nuts on axle ends. Gently tap with hammer to secure.
3. Place heater on wheel support frame assembly. Make sure air inlet end of
heater is over wheels.
4. Place front handle (and rear handle if provided) on top of fuel tank flange.
Insert screws through handle(s), fuel tank flange and wheel support frame.
Attach nut finger tight after each screw is inserted.
5. Tighten all nuts firmly.
Hot Air
Outlet
ASSEMBLY
(For 100 and 150 Models Only)
Wheel
Support
Frame
Wheel
Axle
Fuel
Tank
Flange
Extended
Hub
Air Inlet
Screw
Front
Handle
Rear
Handle
Nut
Cap Nut
Figure 4 - Wheel and Handle Assembly, 100/150 Models Only