Filter
Top Products
9
Fig. 10
Fig. 11
Use proper extension cords. Make sure your extension
cord is in good condition and is a 3-wire extension cord
which has a 3-prong grounding type plug and a 3-pole
receptacle which will accept the tool s plug. When using
an extension cord, be sure to use one heavy enough to
carry the current of the air cleaner. An undersized cord
will cause a drop in line volt age, resulting in loss of power
and overheating. Fig. 10 shows the correct gage to use
depending on the cord length. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier
the cord.
EXTENSION CORDS
TOTAL LENGTH OF
CORD IN FEET
0 - 25
26 - 50
51 - 100
101 - 150
GAGE OF EXTENSION
CORD TO USE
18 A W G
16 A W G
14 A W G
12 A W G
ON/OFF SWITCH
The Air Cleaner is equipped with an in-line rocker switch
(M) Fig.11, located on the power cord (N). To st art or stop
the motor, press downward on the rocker switch. NOTE:
The switch has markings on the side to determine the
on/of f position. W e suggest that when finished with the
air cleaner, the switch be turned of f rather than unplug -
ging the unit.
OPERATIONS
1. NOTE: The air cleaner may produce a slight odor for the first couple hours of operation due to the protective coating
which is applied to internal components. This odor will dissip ate and should be disregarded. IMPORTANT:Never oper-
ate the air cleaner without air filters in place.
2. Fig. 12 illustrates the air cleaner as it can be used in bench-top sanding applications.
N
M
Fig. 12