Filter
Top Products
7
Fig. 5
Fig. 6
MOUNTING THE AIR CLEANER TO THE CEILING O R
OVERHEAD SUPPORT
W ARNING: THIS TO O L WEIGHS APPROXIMATELY
50 POUNDS. MAKE CERTAIN THEUNIT IS SECURE-
LY SUPPORTED WHENMOUNTING TO A CEILING
O ROVERHEADSUPPORT.
1. Locate (4) one inch eye-bolt s, and (4) 1/4-20 flange
nut s supplied with the unit.
2. Remove four screws, one of which is shown at (C)
Fig. 5, from the top of air cleaner (D).
3. Thread one flange nut (E) Fig. 5, approximately half-
way onto each eye-bolt (F) supplied, as shown.
4. Thread each eye-bolt (F) Fig. 5, into each of the four
holes where screws (C) were removed in STEP 2.
5. Fig. 6, illustrates the four eye-bolt s (F) attached to
top of air cleaner.NOTE: To adjust the height of the air
cleaner, loosen flange nuts (E) and rotate eye-bolt s as
necessary.Make certain the flange nuts (E) Fig. 6, are
tightened down against the surface of the air cleaner
after height adjustments are made.
When suspending the air cleaner from the ceiling or
other overhead support, make certain the supporting
hardware (not supplied) is securely anchored into a
wooden supporting structure as shown in Fig. 7.
W ARNING: NEVERSECURE MOUNTING HARDWARE
TO D RY WALL, DROP CEILING TILE/FRAME, OR NON-
STRUCTURAL MEMBERS.
W ARNING: Keep a minimum of seven feet between bottom of air cleaner and the floor surface.
D O N O T use rope, cable or power cord to suspend the unit from the ceiling. We recommend that a chain should
be used and rated for a minimum of a 100 lb. working load to firmly support the air cleaner. IMPORTAN T:When
determining a location to mount the unit, the air cleaner will operate more efficiently when the air flow is unre-
stricted. Do not locate the unit in a corner or near any heating or cooling vents.
F
E
C
D
F
E
Fig. 7