Filter
Top Products
Operation
TURNING THE APPLIANCE ON
Plug the appliance into the socket. Two lines appear on the
display indicating that the appliance is in standby. You can con-
trol the appliance with the remote control (see page 11) or with the
control panel.
OPERATION WITH CONTROL PANEL
Press the ON/STAND BY button (A). When turned on, the air conditio-
ning unit starts operating in the same mode as when it was turned off.
Press the MODE button (B) until the indicator light corresponding
to the required mode lights up:
Indicator light (C): air-conditioning mode
Indicator light (D): dehumidifying mode
Indicator light (E) : fan mode with air filtration
Indicator light (C-D-E) together: smart mode
After selection, the flaps open at a preset angle.
When the air conditioner is turned off, the flaps will close.
AIR-CONDITIONING MODE
Ideal for hot humid weather when you need to cool and dehu-
midify the room.
To set the operation of the appliance correctly, press the “+“ (G)
or “-“(P) buttons until the desired temperature is displayed.
Then select the fan speed by pressing the SPEED button (U) until the
indicator light corresponding to the required fan speed lights up.
MAX: the air conditioning unit operates at maximum to reach
the required temperature as rapidly as possible
MED: reduces noise levels but still maintains a good level of
comfort
MIN: for silent operation
AUTO: the appliance automatically selects the most suitable
fan speed in relation to the temperature set on the digi-
tal display
The most suitable temperature for the room during the summer
varies from 75° - 81° F (24 to 27°C).
You are recommended, however, not to set a temperature
excessively lower than the outside temperature.
DEHUMIDIFYING ????
Ideal for reducing humidity in spring and autumn, during rainy spells
or in damp rooms. Place the appliance in the room without fitting
the air exhaust hose (12) and the intake hose (19). After selecting
dehumidifying mode, the light (D) comes on. Press the “+“ (G) or “-
“ (P) buttons until the required humidity level is displayed. At the
same time, the Auto fan light (Q) comes on as the appliance auto-
matically selects the most appropriate speed. Water is removed
from the air and collected in the condensation tank (8) at the back
of the air conditioner.
78
50
Depending on the model, the temperature on the display is shown in °C or °F. However, the illu-
strations in the manual give the values in °F.
8