Filter
Top Products
Remote control functions
cally and the symbol appears on the display.
Note: in “SMART” function, the temperature is controlled automati-
cally. However, if the required temperature has not yet been rea-
ched, it can be reduced or increased by a maximum of 4°F
(approx. 2°C) by pressing the buttons.
The appliance automatically establishes the operating mode (air-
conditioning, fan, heating) and the optimum fan speed.
With the “SMART” function activated the display on the control
panel shows and the three indicator lights (C/D/E) will come on.
SLEEP FUNCTION
The automatic “SLEEP” function is ideal for the night-time as it ena-
bles operation of the air-conditioning unit in the air-conditioning
mode to be gradually reduced until it shuts down completely (after
eight hours).
To select “SLEEP” function, proceed as follows:
•Press the button (I) to turn the appliance on.
• The symbol flashes on the display and a “beep” indicates
that the air-conditioning unit is on.
•Press the MODE button (A) a number of times until the symbol
of the function required appears on the display.
•Then select the required temperature by pressing the buttons.
• Now press the SLEEP button (F) to set the night function. The
symbol is displayed. With the “SLEEP” function activated, the fan
operates at low speed.
On the control panel the indicator light (F) comes on.
Press the SLEEP button again to go back to the previous mode.
Note: The SLEEP function maintains the room temperature at the optimum level, avoi-
ding excessive increases or drops in the temperature, with silent operation.
The flow of air decreases, while the room temperature varies gradually according to the
comfort requirements: increases of approx. 2°F (approx.1°C) after 60 minutes and approx.
4°F (approx.2°C) after 2 hours (it switches off altogether after eight hours).
PROGRAMMING THE TIMER
The timer can be used to delay appliance start up or shut down.
This avoids wasting electricity by optimizing operating periods.
Programming shut-down
•With the air-conditioning unit on, press the TIMER button (E). The
time is displayed and the “h” symbol flashes. Set the time when
you want the appliance to go off using the buttons (from
30 minutes to 24 hours). During the first ten hours, you can select
half hour intervals. For times greater than ten hours, one hour inter-
vals can be selected.
•Press the TIMER button again to confirm the selection. A count-
down of the time left is displayed.
• At the end of the set time the appliance switches off automatically.
•To cancel the set time, press the TIMER button again. You will
hear a “beep”.
Programming start-up
•With the air-conditioning unit off, press the TIMER button (E). The
time is displayed and the “h” symbol flashes. Set the time when
you want the appliance to come on using the buttons (from
30 minutes to 24 hours). During the first ten hours, you can select
half hour intervals. For times greater than ten hours, one hour
intervals can be selected.
•Press the TIMER button again to confirm the selection.
• At the end of the set time the appliance switches on automatically.
•To cancel the set time, press the TIMER button again. You will
hear a “beep”.
79
F
14
18