Filter
Top Products
26
Preparation for use
HOW TO USE THE AIRCONDITIONER WITH WATER
These air conditioners can use both air and water to cool the condenser (the hot part) of the air
conditioner.
To utilise the full potential of your air conditioner, the tank needs to be filled with water. The water
is used. To increase the cooling power and reduce the noise level and energy consumption of the air
conditioner. The water that is used in then expelled from the machine as water vapour through the
exhaust hose (it does not go into room).
Always use clean top water (which doesn’t contain salts). As a rule the water will usually last about 8
hours however this depends on the conditions within the room, such as temperature, humidity, insula-
tion and aspect and number of people. In turbo mode the water will also be used more quickly.
You may also use the airconditioner on air cooling only (without filling the water tank . If you only requi-
re the lower cooling power.
16
8
A) To open the front panel
grip either side of the
panel and gently pull the
panel towards you and
upwards. Remove the tank
Lifting it forward.
8
6
B) Turn the tank upside down
and remove the plug,
remove the extendible
tube and fill the tank, lea-
ving it on the ground.
C) After completing the fil-
ling procedure, replace
the extendible hose,
replace the cap and
screw it in tightly. Return
the tank to its place, with
the writing FRONT clearly
visible. Carefully hold the
panel in the centre and
lower to its closed posi-
tion.
During the "water functioning" operation and in particularly silent locations (eg the bedroom) a
slight gurgling sound may be heard. This is completely normal.
IMPORTANT: if the room temperature is 32°C or over the airconditioner must be operated with with
water in the tank.
2