Filter
Top Products
30
VENTILATION/PURIFICATION
This is ideal for dusty or polluted areas; in effect, the appliance
recycles and purifies the air using the dust filters and 3M Filtrete™
electrostatic filters fitted. Adjust the fan speed by pressing the
“FAN” (Q) button, as illustrated in the air conditioning function.
Bear in mind that the higher the speed, the greater the volume
of air filtered; by selecting the “Silent” speed, less air is filtered, but
the noise level is low.
“AUTO” function cannot be selected in this mode.
The display will show the fan speed selected.
PROGRAMMING THE TIMER
The timer programs the appliance to switch on and switch off.
This will save electrical energy by optimizing the operating times.
The timer is set using the buttons + (F) or – (G); these increase and
decrease by one hour at a time, but if pressed for more than 2
seconds will automatically change the time more quickly, up to
a maximum of 24 hours.
How to set the delayed start function
• Connect the appliance to the mains supply and press
ON/OFF button: next, select the required operating mode
(temperature, fan speed etc.)
•Press the ON/OFF button again: the appliance will go into
stand-by mode.
•Press the timer button (1): on the display the two central seg-
ments will start to flash.
• Set the number of hours after which the appliance should
switch on, by pressing the + or – buttons.
The indicator (L) on the display will continue to flash until the
appliance starts operating.
The appliance can be programmed for up to 24 hours in advan-
ce.
How to set the delayed stop function
• The appliance can be programmed for delayed stop from
any of the operating modes (air-conditioning/dehumi-
difying/purification/ventilation.
•Press the Programmer button (1): on the display the two cen-
tral segments will start to flash.
• Set the number of hours after which the appliance should
switch off by pressing the + or – buttons.
The indicator (L) on the display will continue to flash until the
appliance switches itself off. It will then go into Stand-by mode.
“Silent”
speed
“Min”
speed
“Max”
speed
25
Operation
FX160/400ECO GB 20-06-2002 16:51 Pagina 30