Filter
Top Products
7
WARNINGS
You must leave the heater plugged into the outlet to keep the timer
memory programmed.
If the heater loses its power supply for more than 2 minutes, (e.g. switched off at the outlet or
in the event of a power failure), the heater’s programs will be lost, and the heater will not
work until reset.
SAFETY DEVICE
A safety device switches the heater off in the event of everheating. To restart the heater,
call the nearest service center.
Note: when the safety device intervenes, the heater doesn’t
heat but the display works.
MAINTENANCE AND SERVICE
Always remove the plug from the power outlet and allow the radiator to cool. Wipe radiator
with a soft damp cloth, do not use detergents and abrasives. Should the radiator not be in use
over a certain length of time, wind the cable round the holder and store it in a dry place. This
appliance has been built to give many years of trouble free service. In case of malfunction or
doubt, do not try to repair the heater by yourself: it may result in a fire hazard or electric
shock. Call the nearest Service Center (see attached list of Service Centers) or call customer
support at 1-800-322-3848.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. lf this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Modifications not approved by the party responsible for compliance could void user’s
authority to operate the equipment.