Filter
Top Products
4
OPERATION AND USE
1) SETTING THE CLOCK
For the first time, set the clock to the correct time, proceeding as follows:
• Press the button “h” until the display shows the correct hour setting.
• Press the button “min” until the display shows the correct minute setting.
When setting the clock time, the numbers will flash on the display.
The flashing numbers will continue for a few seconds until the adjustment has finished.
Once the numbers stop flashing the clock will start working.
To change the time, press and hold the “h” or “min” button for at least 5 seconds or
until the numbers are flashing. Then proceed as above to modify both hours and minu-
tes.
2) MANUAL OPERATION
To operate the appliance in “manual” mode, press the “ON MODE” button.
To set the required power level: press the “ON MODE" button, and then press again one or
more times within 5 seconds to select the power level, as per the following sequence:
Maximum power
Medium power
Minimum power
Off
If Maximum power has been selected, adjust the “ +” or ” -” button to the desired comfort
temperature, from 42 to 95°F (5 to 35°C). By pushing once the “ +” or “ -” button the desi-
red temperature (shown on the right side of the display) will increase or decrease of 1°F.
Press and hold the button to move through the temperature mode quickly.
correct time
Set temperature
set temperature
correct time