Filter
Top Products
Place the dehumidifier in a suitable position, a halfway or landing are generally good sites.
The appliance must be positioned so that the air intake and air outlet grills are at least 20 inches
away from any wall or obstacle to ensure adequate ventilation.
Condensate can be drained in one of two ways:
A)
Discharge into the tank
Your unit is supplied with a tank,which is positioned on the left side (Fig.1) of the unit to
accumulate water removed from the air.
The condensate generated by the dehumidifier can be discharged directly into the tank.The
tank is easy to extract when it needs to be emptied without spilling.
Note: make sure the tank is
in position and the pump
switch is in the OFF position
IMPORTANT: The water collected is not drinkable. Please throw it away.
B) Direct draining
The exclusive Condensation Removal System,allow you to use a hose that extends 16 feet
(4.9 m) in height to drain the water. If you want the water to flow directly to a drain, connect
the condensation discharge tube supplied to the connection pipe located on the lower part
of the unit (Fig.2-3). Turn then the pump switch to ON.
Note: With the condensation discharge hose missing and the pump switched ON, a safety
device will make the machine discharge directly into the tank.
Note: It is possible to install the unit permanently and have the hose passing through an
opening or window. Create a hole with a drill bit 0.035 inches (9mm) in size. At the end of the
season, the hole can be covered with a plastic or rubber stopper.
1 PUSH
2
ENGLISH
5
Installation
fig.1
How to
connect
How to
disconne
fig.3
fig.2