DCS BGB132-BI Burner User Manual


 
14
TROUBLESHOOTING
Burner won’t light when the ignition
is pushed.
Burner flame is yellow or orange, in
conjunction with the odor of gas.
Low heat with knob in “HI”position.
Remove the burner grate. With the control knob in the “OFF”
position,listen to the electrode while engaging the ignition.
You should hear a spark jump inside the electrode cap.When
the spark jumps,it makes a ticking sound.
If there is no spark........
Could be a dead battery.
Or the air gap between an electrode tip and a contact
metal is too far (gap should be 1/8”) or dirty.
If there is a spark...is there gas supplied to the unit and is the
line purged of air? See Fig.03 and Fig.04.
Does the other burner of a dual burner operate?
Check the orifice for blockage or venturi blockage.
Check the burner for obstructions or dirt.See Fig.09.
Check for proper gas supply or wrong gas.
Is the Side Burner in a dusty area? Move to less dusty area if
possible.
Is the fuel hose bent or kinked? See Fig.03 and Fig.04.
Is there adequate gas supply available? If it is only one burn-
er of the dual burner unit that appears low,does the burner
need cleaning? See Fig.09 and Fig.10.
If using LP gas,check for empty tank or low.
PROBLEM WHAT TO DO