Filter
Top Products
Can
adian Comfort Industries V04 31 PELPRO OWNERS MANUAL
Copyright 2004
www.pelprostoves.com Dansons Group Inc.
CLEANING YOUR EZ–CLEAN GRATE
To clean the grate, pull rod on front of stove back and forth a few times, once or twice per day.
IMPORTANT: Be sure you PUSH the rod in fully for normal operation.
INSERTING, REMOVING & ADJUSTING THE BURN GRATE
The burn grate top, (G), must fit and seal firmly on the upper lips, (H), of the burn box, (A). An improper seal will
allow incoming combustion air to escape, not passing up through the burn grate thus reducing the amount of
combustion air in the area needed to efficiently burn pellets.
A
B
C
D
E
F
G
H
- Burn box
- Burn grate spacer,
(follower)
- Pin, securing spacer to rod
- EZ-Clean pull rod
- Burn grate bottom
- Adjustment tab, burn grate
- Burn Grate top
- Upper Lips
Adjusting the burn grate:
Steps in adjusting the burn grate top so the lower end of the burn
grate top sits firmly on the top of the burn grate bottom, (E),
Removal of burn grate top:
Lift upward (1) while sliding lip out from under
lip of slide (2) then pull out toward outside of
burn box (3)
Installation is reverse of this.
Grasp the burn grate adjustment tab (F), with a pair of pliers and bend it slightly to left or
right (and re-install into burn box) until its length allows the burn grate top to rest tightly
onto the burn grate bottom. (Location J)