Filter
Top Products
4 5
Installation
Tools needed: Small Phillips Screwdriver;
Large Phillips Screwdriver; Small Standard
Screwdriver.
Set Up:
1. Install the back-up battery (included) into the auto
dialer. Use a small Phillips screwdriver to remove screw
above battery cover (Figure 1-2). Remove cover by
sliding downwards. Plug in battery pack making sure
not to force onto pins incorrectly. Put battery pack in
space provided, close battery cover, and replace the
screw.
3. Connect the power supply to the dialer by inserting
the red wire into the 12V+ terminal and the black wire into the OV terminal (Figure 2). Using a
small standard screwdriver, turn the screws on the terminal to secure the wires.
4. The dialer can support two alarm trigger inputs (normally open) plus a tamper alarm output
(normally closed).
Figure 1
1 4 5 3 2
AD-01 Slave Manual.indd 4 10/15/2009 10:20:44 AM