Filter
Top Products
10 11
HOW TO OPERATE THE AUTO DIALER
How to Arm the Alarm System/Turn the Dialer ON:
1. Check that the voice message and at least one phone number has been programmed
into the Auto Dialer.
2. Press 1 2 3 4 > ENTER. The Auto Dialer will show ‘ON’ on the display.
3. The alarms will become active after the delay time you have set has expired.
Quick guide: Press 1 2 3 4 > ENTER
How to disarm the Alarm System/Turn Dialer OFF:
To disarm the Alarm System or to stop the Dialer from dialing out after either the tamper
switch (if connected and active) or an alarm input has been activated, key in the four digit
user password code followed by ESC. The Auto Dialer will revert to the ‘OFF’ mode and must
be re-set to the ‘ON’ mode as above.
Quick guide: Press 1 2 3 4 > ESC
AD-01 Slave Manual.indd 11 10/15/2009 10:20:45 AM