Filter
Top Products
8
OPERATION
1. Insert the AC
plug of outdoor
unit into a
pronged 220V
AC outlet
AC Outlet
and Plug
NOTES:
• Never connect the AC line cord plug to other than the
specified voltage (220V).
• The new air conditioner system should be on it’s own
220V circuit. Contact your local electrical installer for in-
stallation.
• Use the recommended power cord and wire only (refer
to page 15)
CONNECTING THE AC CORD
Only the power plug of outdoor unit is connected to AC outlet, and the power of indoor units were supplied with AC con-
nection cords from outdoor unit. To supply the system with AC power, follow the procedures bellow:
Plug into 220V AC Outlet. (not supplied)
SETTING THE UNIT FOR REMOTE OPERATION
After the unit is fully connected and plugged in, it can be turned on. To turn the unit on and set it for remote operation,
follow the procedures below:
1. Open the indoor unit’s cover and make sure the EMER-
GENCY/REMOTE switch is set to the REMOTE position;
this will allow the unit to operate with the remote controller.
2. Press the ON/OFF button on the remote controller to
turn on the unit. The On LED will light on the indoor
unit and “ON” will light in the remote display.
To select the various modes
and settings, read the follow-
ing pages.
THREE MINUTE COMPRESSOR DELAY
• After turning the indoor unit on and setting it for air con-
ditioner operation, the compressor (outdoor unit) will
not come on for three minutes. This is a feature that
will protect the compressor from damage due to quick
start and stops.
EMR. REMOCON
EMERGENCY/REMOTE Switch