INSTALLATION DIAGRAM
15
Below is an overview for the connection of the Indoor unit to the Outdoor unit. The pages following will give detailed
instructions for full installation. Remember to read the complete Installation section and follow all the safety instructions
fully when installing the Indoor and Outdoor units.
OVERVIEW
This appliance must be installed according to national power supply acquirement.
NOTES:
• After installation it must be
possible for the user to
disconnect the power supply
plug.
•
If
the
AC
outlet
is a 3-pronged
type or other, have an
electrician install a new
outlet.
• Contanct service man when
replace the power cord set.
Drain
Hose
Ground Wire
(Not Supplied)
3/8" side piping
Signal Wire
1/4" side piping
Drain Hose
Wall
Wall
Cap
Drain
Hose
Pipes
(Not Supplied)
Signal wire
Copper
Tubing
At least 30cm
(11.8in) from unit
60
cm
23.6
inches
cm
10
cm
3.9 inches
60
23.6
inches
AC Outlet
and Plug
Plug into 220V~240V
The added refrigerant according to the extention tube
length: 30g/m [Standard length: 7.5m]
- Adding additional tubing will decrease efficiency.
AC Outlet
(Not supplied)
10cm (3.95in)
from ceiling
30cm (11.8in) from
side wall
30cm (11.8in)
from side wall
10cm (3.95in) from
side wall
10cm (3.95in) from
side wall
10cm (3.95in) from
side wall
Wall
Bracket
Connecting
cable
Connecting cable
(Not supplied)
Wrap with
Tape
Maximum Height 7M (21Ft)
15M (49Ft)
Maximum Length