Crane EE-5949 Humidifier User Manual


 
5
OPERATION AND USE
BEFORE EACH USE:
CHECK HUMIDIFIER PLACEMENT
Place the Humidifier on an elevated, non-metallic, lint-free, waterproof, level surface at
least 2 feet above the floor.
DO NOT place the humidifier on carpet or a towel. The fan vent is located on the
bottom of the humidifier base. The fan vent MUST NOT be obstructed.
DO NOT place the humidifier on a wood surface or near furniture that can be
damaged by too much moisture.
CHECK WATER LEVEL SENSOR
Make sure that the Water Level Sensor is secured properly and not obstructed.
CAUTION:
DO NOT operate the humidifier without water in the Water Tank.
DO NOT plug or unplug the Power Cord with wet hands as electric shock could occur.
ASSEMBLY
1. Locate battery compartment underneath humidifier. Remove the plastic protective
strip from the LCD support batteries.
2. Turn Water Tank upside down and unscrew Water Tank Cap.
3. Fill Water Tank with cool water. DO NOT fill water all the way to rim.
DO NOT use hot water. Use cool tap water.
DO NOT add any medication, essential oils, or salt.
4. Screw Water Tank Cap back onto Water Tank. Turn the Water Tank over and place
on Water Basin, making sure it fits perfectly.
Note: Do not attempt to move the humidifier while Water Tank is placed on Water
basin. Doing so may cause leakage of water and/or Water Basin to overfill.
5. Connect the adapter cord into the 18V DC opening in the back of the humidifier base.
Connect the power adapter to a 120V outlet.
6. Press Power / Cancel button on front of Water Basin to turn on. The LCD Display will
illuminate and the mist will begin to emit. Turn the Nozzle 360 to adjust mist
output.
7. Press Power / Cancel button again to turn off.
SETTING THE CLOCK
As soon as the humidifier is connected to the power source, the LCD display on the clock
will illuminate blue.
1. Press the FLOW / SET button and hold until the first two numbers blink.
2. Press the LIGHT / FUNCTION button to adjust the correct hour.
3. Press the FLOW / SET button again and the last two numbers will blink.
4. Press the LIGHT / FUNCTION button to adjust the correct minutes.
5. Press the FLOW / SET button several times until the correct clock time appears
on display.
NOTE: You will need to press through other functions until the clock time you
set appears.