Filter
Top Products
Assembmy
TO AVOID INSTALLATION DIFFICULTIES, DO NOT RUN THE GARAGE DOOR OPENER UNTIL YOU HAVE
COMPLETED STEP 8, PAGE 15.
STE P I Assemble Tee Rail & Attach Cable Pulley Bracket
,.,,i ::::=
TEE RAIL BACK _'
(TO CHASSIS V
CAUTION: Do not tighten the lock nuts until bolt ./ /A
necks are seated in square holes°
TeeRail /////
(End Section___
"eL_ C.r.._ea0,
_,_ / ,_/7_ki_ !f 4".20xl/2''
Tee Rail
(Center Section
'_. Flange
1/4" Lock Nut
_/'_" Squar_ " g
Align front end of tee rail with cable pulley bracket and
connect as shown, Tighten screws and nuts securety_
PROCEDURE: Place the 3 Tee rail sections on a flat
surface for assembly. TH IS IS IMPORTANT. The center
section has two connection flanges., The end sections
are identical.
Refer toillustration. BE SURE CENTER SECTION IS
POSITIONED ON THE CORRECT SIDE OF TEE
RAIL. (When assembled, Tee rail has a front-to-back
position as shown).
Bolt center rail section to end sections with the hard-
ware illustrated_
SQUARE NECKS ON CARRIAGE BOLTS MUST BE
SEATED IN SQUARE HOLES IN TEE RAILS,
Cable Pulley
Bracket
Lock Washer
5f16"
Nut
r 5t16"