Craftsman 39535006 Garage Door Opener User Manual


 
FEATURES OF YOUR OPENER
1o Opener Lights: Turn on and off automatically,
with 4-1/2 minute illumination for your safety and
convenience. Provide constant light when Work
Light control button is pressed..
2,. Safety System: Independent up and down force
adjustment.. Door reverses automatically when ob -
structed in DOWN direction Door STOPS when
obstructed in UP dkection
3o Emergency Disconnect: Putl cord disconnect
permits manual door operation.
4o Automatic Reconnect: Trolley halves reconnect
for automatic operation when opener is energized
after emergency disconnect.
5_ Motor Power: 1/2 horsepower permanently lubri-
cated motor with automatic reset
6., Digital Radio Controls: 19,683 codes from which
to choose Can be changed easily by the owner..
7o Easy Limit Adjustment: Limits of door opening
and closing adjusted by turning screws without re-
moving chassis cover:.
8, Vacation Push Button: When the Vacation Push
Button is ON, the openerwill not operate from the
transmitter. The door will operate in the UP direc-
tion ONLY from the Wall Control (or optional Key
Switch accessory, Page 5)
SPECIFICATIONS
MOTOR SAFETY
Type . 1/2 horsepower permanent split capacitor
Speed t500 rpm
Volts ._ 120 Volts AC - 60 Hz Only
Current 4 5 amperes
DRIVE MECHANISM
Gear reduction
Drive
Lubrication
Length of Travet
Travel rate
Lamp
Door linkage
16:1
Chain & cable with two-piece trolley on
steel Tee rail
Motor is setfqubricated. Drive shaft bronze
off-life bearings
Adjustable to 7-1/2 feet
6 to 8 inches per second
On when door starts in travel, off 4-1/2
minutes after stop, Also separate Work
Light push button
Adjustable door arm PuIi cord trofley
release
Personal
Electronic
Electrical
Limit device ....
Limit adjustment
Start circuit
Push button & automalic reversal in down
direction. Push button & automatic stop
in up direction
Independent up & down force adjustment
screws
Motor overload protector and low voltage
push button wiring
Circuit actuated by limit nut
Screwdriver adjustrnenl on side panel
Low voltage push button or radio controI
DIMENSIONS
Length (overall) . . 122-t/2 inches
Headroom required 2 inches
Shipping Weight 43 pounds
YOU'LL NEED TOOLS
During assembly and installation of your opener, the instruction will call for use of various hand tools. Have a
stepladder handy, and those tools illustrated below: Hammer, electric drill (also 3/16" and 5/16" drill bits), screw
driver, adjustable end wrench or socket wrench kit, wire cutters, tape measure, pliers and hack saw.
Tape Measure
Pliers
Hack Saw
Wire Cutters
Claw Hammer
Screwdriver
Stepladder Adjustable End Wrench
Electric Drili Socket Wrench