Filter
Top Products
Assembly
i i iii ii, iii, ,JIJ,,llJ,lL,II I,,,,,,',,
STEP 4
, iiii i111 ,!l
ii, ,i,,,11,,11 i, i, ii ,i i
Install Chain and Cable
Lii iii ii iiiiiiiiii I IIIII iiIII II ii,11,111111 Lii
_11 ii1
DO NOT REMOVE CHAIN AND CABLE FROM CARTON.
Detach cable from side of carton and fasten to trolley with
a master link from coin envelope,
MASTER LINK PROCEDURE: Push pins of master link
bar through loop of cable and hole in front end of trolley
(A) as shown° Push cap over pins and onto notches. Slide
clip-on spring over cap and onto pin notches untilboth pins
are locked in place.
Caution: Keep the chain taut while installing to help
prevent kinking.
With trolley against the screwdriver, dispense cable around
pulley. Proceed back around opener sprocket (B_.be sure
sprocket teeth engage chain- and forward to the threaded
trolley shaft (C).
B lnstaI| Chain
inThisI_recl_n
OpenerCh_,_s
Use second master link to connect the chain to the fiat
end of shaft as shown. Check to make sure chain is not
twisted,
REMOVE SCREWDRIVER.
A
Tab Slot
P_ate
ATTACH SPROCKET COVER TO CHASSIS: Insert back
tab in chassis slot. Then bend cover forward and insert
front tab in slot provided on mounting plate.
................................. ,,, 1111 , [ H " , ,_llJ,,,m,,,, ,,1 II I
8