Filter
Top Products
Receiver and Remote Control Programming
To comply with FCC rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing
the code sening or replacing the battery. THERE ARE NO
OTHER USER SERVICEABLE PARTS.
Models with 3-function remote controls: The
remote control(s) has been factory set to operate
with the large push button. However, you can use
either of the two small buttons, if you prefer. And,
the 3-function remote control(s) can also activate
additional garage door openers and/or light controls.
Below are instructions for programming your opener
to match the other buttons on your remote controls
and any additional remote controls you may
)urchase. See available accessories on page 38.
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the door push button(s) or remote
control(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
53000SRT Series Garage Door Openers
(With "SRT" Button)
Your "SRT" garage door opener will operate with as
many as four "SRT" portable remote controls and
one Multi-Function Keyless Entry.
To Add A Remote Control
1. Press and ho/dthe selected remote push button,
see Figure 1.
2. Then press and release the "SRT" (learn) button
on the back panel of the opener, Figure 2. The
opener light will flash once.
3. Release the remote push button.
Now the opener will operate when the remote
control push button is pressed.
If you release the remote control push button
before the opener light flashes, the opener will
not accept the code.
To Change the Selected Push Button
On the Same Remote Control
If you decide to use a different remote control button
than originally programmed into the opener, you
need to erase allthe learned codes and reprogram
each remote control used to operate the garage
door opener.
To Erase All Remote Control Codes
• Press and hold the "SRT' button on the opener
panel until the indicator light turns off (about 6
seconds). AIIthe codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1,2 and 3 for each
remote control in use.
Code programming instructions are also located
on the opener panel.
Figure I
Select aremote control push
butlon to operate opener
3-Function
Remote Control
Figure 2
Garage Door Opener
(With "SRT" Button)
'SRT" (learn) Indicator BACK
Button Light PANEL
To Add the Keyless Entry
We recommend that you program your code before
you install the Keyless Entry. You will not need
assistance, and you can test the reception at the
mounting location before installation.
1. Choose a 4-digit code using numbers from 0 to 9.
You can use a number more than once (for
example, 4, 0, 4, 1). Press the selected code digits
on the keypad.
2. Press and ho/dthe Enter button while you press
the "SRT" (learn) button on the opener panel. The
indicator lightwill blink and the door will begin to
move.
3. Release the Enter button. Now the opener has
learned the selected keypad code.
To ensure that your portable remote control codes
were not disturbed while you were programming the
Keyless Entry, test your remotes and reprogram
them if necessary.
To change the code at any time, repeat steps 1-3.
33