Filter
Top Products
Installation Step 7
Instafl the Light and the Lens
Instal| the lights
- Install a 75 watt me_imum light bulb in the stoker.
The light will turn ON and remain lit for
approximately 4q/2 minutes when _wer is
connected. Then the light will turn OFF.
, If the bulb bums out prematurely due to vibration,
replace it with a standard neck "Garage Door
Ught
Install the lens (except for Modef 53225)
Apply slight pressure on IJsesides of the _ens and
slide _e tabs into the slots in the end p_ef
, Reverse the procedure to remove the fens°
lnstalJation Step 8
Attach the Emergency Release
R®e
Do not use the red handle to pull the door
open or closed, The rope knot couid become
untied and you could Carl. Use the emergency
release only to d_sengage the trolley and:, if
possible, only when the door ts etosed.
Garage doors are heavy. If the door is open
when the handle is pulled, the door could
close inadvertently if ft is not properly
balanced, Sedous injury may result to persons
under the door, Make sure the doorway ts clear
of persons and obstructions before pulling
handle when door is open,
- Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads dght side
up as shown Secure with an overh_d keel
The knot should be at least 1" from the end of the
rope to prevent slipping,
, Thread the other end of the rope through the hole in
the release arm of the outer trolley
* Adjust rope length so the handie is 6 feet above the
floor. Secure with an overhand knoL
If it is necessary to cut the rope, heat seal the cut
end with a match or lighter to prevent unraveling.
t9