Filter
Top Products
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance does not have a pilot. It is • If you cannot reach your gas supplier, call
equipped with an ignition device which the fire department.
automatically lights the burner. Do not try
to light the burner by hand. C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
B. BEFORE OPERATING smell all around the not push in or turn by hand, don’t try to repair
appliance area for gas. Be sure to smell next it, call a qualified service technician. Force or
to the floor because some gas is heavier than attempted repair may result in a fire or explosion.
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS: D. Do not use this appliance if any part has been
• Do not try to light any appliance. under water. Immediately call a qualified service
• Do not touch any electric switch; do not technician to inspect the appliance and to
use any phone in your building. replace any part of the control system and any
• Immediately call your gas supplier from a gas control which has been under water.
neighbor’s phone. Follow the gas supplier’s
instructions.
OPERATING INSTRUCTIONS
1. STOP! Read the safety information above on 5. Remove front panel.
this label. 6. Pull the gas control lever DOWN clockwise
$
2. Set the thermostat to lowest setting. to “OFF”. Do not force.
3. Turn off all electric power to the appliance. 7. Wait five (5) minutes to clear out any gas. Then
4. This appliance does not have a pilot. It is smell for gas, including near the floor. If you
equipped with an ignition device which auto- smell gas, STOP! Follow “B” in the safety
matically lights the burner. Do not try to information above on this label. If you don’t
light the burner by hand. smell gas, go to the next step.
8. Push gas control lever UP counterclockwise
%
to “ON”.
9. Replace front panel.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the
instructions “To Turn Off Gas To Appliance”
and call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting. 4. Pull the gas control lever DOWN clockwise $
2. Turn off all electric power to the appliance to “OFF”. Do not force.
if service is to be performed. 5. Replace front panel.
3. Remove front panel.
Page 10
Gas
Inlet
Gas control
knob shown
in “OFF”
position