Filter
Top Products
19
Maintenance
INSTALLATION
|
Uninstallation Existing Toilet Seat
|
Installation the Product
Uninstallation Existing Toilet Seat
1. Remove the fixing nuts of the existing seat and
separate the existing toilet seat
1
and the seat cover
2
.
Keep the removed seat and seat cover in a shaded place.
Installation the Product
1. Turn off the main water supply valve
1
and separate
the existing water tank hose
2
.
2. Connect the rubber packing, T-shaped connector,
and water tank hose in order to the existing tap water
pipe.
Please connect the bidet hose to the T-shaped connector.
Please insert the rubber packing between the water pipe and the
T-shaped connectior necessarily. Firmly rotate the nuts below and
on top of the T-shaped connector to the end clockwise.
3. Please connect MF filter to the product body.
Please assemble by rotating the MF filter on the filter holder in
the lower left side of the bidet body.
If the MF filter is assembled completely, as the bidet may not
function normally, please be careful.
4. Put the fixing plate and the fixing slider on the bidet
as the figure. Insert the fixing screw to the filter
holder, push the fixing rubber and the fixing washer,
and tighten the fixing nuts.
Tighten the fixing screws firmly so that the bidet body won’t be
shaky on the toilet. Users may fall off the seat and get injured.
1014692 BA07 »ç¿ë¼³¸í¼- ¹ÌÁÖÇâ_(08.09.10).indd 19 2008-09-10 ¿ÀÀü 11:37:10