Filter
Top Products
TROUBLE-
SHOOTING.
Continued
WARNING
If you smell gas
• Shut off gas supply.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• if you cannot reach your gas supplier, call the fire department.
IMPORTANT: Operating heater where impurities in air exist may create odors.
Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new
carpet or textiles, etc., create fumes. These fumes may mix with combustion air
and create odors. These odors will disappear over time.
OBSERVED POSSIBLE
PROBLEM CAUSE REMEDY
Heater produces a
clicking/ticking noise
ust after burner is lit
or shut off
1. Metal expanding while
heating or contracting
while cooling
1. This is common with
most heaters. If noise is
excessive, contact
qualified service person
Heater produces
unwanted odors
1. Heater burning vapors 1.
from paint, hair spray,
glues, cleaners, chemi-
cals, new carpet, etc.
(SeeIMPORTANT
statementabove)
2. Gas leak. See Warning 2.
statement at top of
page
Open window and
ventilate room. Stop using
odor causing products
while heater is running
Locate and correct all
leaks (see Checking Gas
Connections, page 17)
Heater shuts off in use
(ODS operates)
1. Not enough fresh air is
available
2. Low line pressure
3. ODS/pilot is partially
clogged
1. Open window and/or door
for ventilation
2. Contact local natural gas
company
3. Clean ODS/pilot (see
Cleaning and Mainte-
nance, page 25)
Gasodorevenwhen
controlknob isin OFF
)osition
1. Gas leak. See Warning
statement at top of
page
2. Control valve defective
I. Locate and correct all
leaks (see Checking Gas
Connections, page 17)
2. Replace control valve
Gasodorduring
combustion
1. Foreign matter between
control valve and burner
2. Gas leak. See Warning
statement at top of
page
1. Take apart gas tubing and
remove foreign matter
2. Locate and correct all
leaks (see Checking Gas
Connections, page 17)
Logs set cycles m
pilot, but room
temperature drops to a
lower than ideal level
before log set comes
backon
1. Thermostat sensing bulb
needs to be repositioned.
1. Reposition thermostat
sensing bulb (see instruc-
tionsfor Optional
Positioning of Thermostat
Sensing Bulb, page 29.