Filter
Top Products
Clarke
®
Operator's Manual -FOCUS S17/L17 and S20/L20 Page -17-
EN
How To Remove Rotary Brush or Pad Driver (if
equipped)
To remove the brush or pad driver from the machine, follow
this procedure:
1. Turn the key switch clockwise ("L" models only).
Press the green "ON" button.
2. Raise the brush head by pressing and holding the
brush up switch until brush head is in it's full up and
rotated position.
3. Press the red "OFF" button or turn the key switch
counterclockwise on machines equipped with key.
4 To remove brush, rotate brush in the same direction
to scrub rotation with a quick snapping action until
brush releases (See Figure 21).
5. Reinstall brush housing if removed.
How To Change Or Rotate Cylindrical Brushes (if
equipped)
To install or rotate brushes on the machine, follow this
procedure:
1. Turn the key switch clockwise ("L" models only).
Press the green "ON" button.
2. Raise the brush head by pressing and holding the
brush up switch until brush head is in it's full up and
rotated position.
3. Press the red "OFF" button or turn the key switch
counterclockwise on machines equipped with key.
4 Go to front of the machine and remove thumb screw
from brush door (See Figure 22).
5. Lower door approximately 1/2 inch and slide door
and bearing assembly off shaft (See Figure 23).
6. Remove brush spacer and brush by sliding off of
brush shaft (See Figure 24).
7. Rotate brush or replace.
8. Slide brush on shaft and rotate slowly until drive pins
are lined up with brush slots. Push brush all the way
in.
9. Install brush spacer on shaft.
10. Slide brush door bearing assembly on shaft.
11. Raise door and install thumb screw.
DANGER: Operating a machine that is not
completely or fully assembled could
result in injury or property damage.
Do not operate this machine unless
it is completely assembled. Inspect
the machine carefully before
operation.
How To Prepare the Machine For Operation
Figure 21
Figure 22
Figure 23
Figure 24
C