Cisco Systems PIX 506E Water Heater User Manual


 
7
6 Configuring the PIX 506/506E
The PIX 506/506E comes with a factory default configuration that meets the needs of most broadband
networking environments. The factory default configuration on the PIX 506/506E protects your inside
network from any unsolicited traffic. It is configured to use DHCP on the outside interface to acquire an
IP address. A default DHCP server address pool is included for hosts on the inside interface.
PDM contains a Startup Wizard that lets you easily change settings to suit your needs.
Instances in which it might be necessary to change or make additional changes to the default
configuration include the following:
To create administrative and Telnet passwords
Note We highly recommend that you change the administrative and Telnet passwords from
their default settings to secure the administration of the PIX Firewall.
To configure Point-to-Point Protocol over Ethernet (PPPoE) or a static IP address for an outside
interface
To configure VPN and Auto Update features
LINK On Data is passing on the port.
Off No data is passing on the port.
Table 2 PIX 506/506E Rear Panel LEDs
LED State Description