Filter
Top Products
3-7
Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide
OL-18362-01
Chapter 3 Installing the Cisco ASA 5505
Rack or Wall Mounting the Cisco ASA 5505
Step 9 Allowing the screws in the anchors to go through the holes in the brackets, mount and slide down the
adaptive security appliance.
Figure 3-5 Mounting the Cisco ASA 5505 Chassis
Step 10
Connect the interface cables.
For information on installing the cables
, see the “Connecting the Interface Cables” section.
Rack-Mounting the Chassis
To rack-mount the adaptive security appliance chassis, perform the following steps:
Step 1 Remove the three screws from the bottom of the adaptive security appliance as shown in Figure 3-13.
Discard these screws as you will not need them.
Step 2 Place the wall-mount bracket on the adaptive security appliance. Use the three screws provided in the
accessory kit to screw the wall-mount bracket to the adaptive security appliance as shown in Figure 3-13.
1 Screws
190683
1