Filter
Top Products
6
Program your Opener & Remote
Please note your remote controls and wall plate have
already been programmed into your operator.
Activate the opener only when door is in full view, free
of obstruction and properly adjusted. No one should
enter or leave garage while door is in motion. Do not
allow children to operate push button(s) or remote(s).
Do not allow children to play near the door.
Your garage door opener has already been programmed at
the factory to operate with your remote control and wireless
wall box.
Fix any wall control at a height of at least 1.5m and within
sight of the door but away from any moving parts.
Fix the warning against entrapment label near the wall
control.
Program additional Remote Controls:
Using the purple “LEARN” Button
1. Press and release the purple “learn” button on the opener.
The orange indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the desired button on
the wireless wall control or remote control that you wish to
operate your garage door.
3. Release the button when the opener light blinks. It has
learned the code.
Delete all Remote Control Codes
Please note this deletes all remotes and codes.
Press and hold the PURPLE learn button until the orange
indicator light goes out (approximately 9 sec.).
10
Setting the Limits
Travel limits regulate the points at which the door will
stop when moving up or down. Follow the steps below
to set the limits.
Check that the opener is engaged.
To program the travel limits:
1. Press and hold the black button (3) until the orange
indicator light (2) starts flashing slowly and then release.
Opener lights will dim.
2. Press the BLACK button to move the door UP or the
PURPLE button to move the door DOWN until the door
reaches the desired UP limit.
Check to be sure the door is high enough for your
vehicle. Adjust if necessary.
3. Press the green start button (4). This sets the full UP limit.
The door will travel to the floor and reverse back to the
UP limit. The opener has learned its travel limits.
4. The indicator light (2) will stop flashing when the limits
have been learned.
NOTE: If the door presses excessively on the floor or
reverses before it reaches the floor proceed to #12 of the
“Troubleshooting” section page 9 and follow the instructions
for setting the limits manually.
The force must be learned in order to properly complete
the setting of the limits.
11
or
1
4
2
3
L
i
f
t
M
a
s
t
e
r
Manual Limit setting
With the door in the midway position.
• Press and hold the black button until the orange
LED starts flashing.
• Use the black (up) and purple (down) button to set
the door opening limit
• Press the Green activation button to start the door,
once it starts travelling down, press either the black
or purple button to engage manual limit setting.
• Use the purple and black buttons to set the closing
limit.
• Test door three or four times to check limit settings.