Filter
Top Products
1
The Protector System must be used for all
installations where the closing force as measured
on the bottom of the door is over 400N (40kgf).
Excessive force will interfere with the proper operation
of the Safety Reverse System or damage the garage
door.
After installation, ensure that the parts of the door
do not extend over public footpaths or roads.
Disengage all existing garage door locks to avoid
damage to garage door.
Install the wireless wall control (or any additional wall
control) in a location where the garage door is
visible, at a height of at least 1.5m and out of the
reach of children. The appliance is not intended
for use by young children or infirm persons
without supervision. Serious personal injury from a
closing garage door may result from misuse of the
opener.
Permanently fasten the Warning Label adjacent to
the wall control as a reminder of safe operating
procedures.
Activate opener only when the door is in full view,
free of obstructions and the opener is properly
adjusted. No one should enter or leave the garage
while the door is in motion. Do not allow children
to play near the door.
Disconnect electric power to the garage door
opener before making repairs or removing covers.
SAVE THESE INSTRUCTIONS
WARNING: Failure to comply with the following instructions may result in serious personal injury or property damage.
• Read these instructions carefully and follow ALL instructions carefully
• The garage door opener is designed and tested to offer reasonable safe service provided it is installed and
operated in strict accordance with the instructions in this manual.
These safety alert symbols mean WARNING – a personal safety or property damage instruction. Read these
instructions carefully.
Warning: If your garage has no service entrance door, a 1702E outside quick release must be installed. This accessory allows
manual operation of the garage door from outside in case of power failure.
Keep garage door balanced. Do not let the garage
door opener compensate for a binding or sticking
garage door. Sticking or binding doors must be
repaired. Garage doors, door springs, brackets and
their hardware are under extreme tension and can
cause serious personal injury.
Do not wear rings, watches or loose clothing while
installing or servicing a garage door opener.
To avoid serious personal injury from entanglement,
remove all ropes, chains and locks connected to
the garage door before installing the door opener.
Installation and wiring must be in compliance with
your local building and electrical codes.
The safety reverse system test is very important.
Your garage door MUST reverse on contact with a
40mm obstacle placed on the floor. Failure to properly
adjust the opener may result in serious personal injury
from a closing garage door. Repeat the test once a
month and make any necessary adjustments.
This opener should not be installed in a damp or
wet space.
Take care when operating the manual release
since an open door may fall rapidly due to weak or
broken springs, or being out of balance.
The drive must not be used on a wicket door (door
within a door)
Start by Reading These Important Safety Instructions
Tools Required
2
1. Instruction manual (this document)
2. Stop bracket collar
3. Clamp bracket
4. Release handle and cord
5. 94335 remote control (2)
6. 128LM wireless wall control
7. Extension poles (2)
8. Weight bar
9. Bracket plate
10. Hardware bag
Carton Inventory
1
1. Ladder (or similar device to safely support door weight)
2. Adjustable wrench for U-bolts already installed on the
door
3. 8mm socket, 10mm socket and 13mm extended socket
and socket wrench
4. 12inch socket extension (for minimum sideroom
installations)
5. Drill and 5.5mm drill bit
6. Philips screw driver
7. Marker Pen
!
2
4
5
6
7
8
1
10
Installation and operating instructions
for rolling door opener Model RDO800
Old Stones Bower Hinton
Martock
Somerset TA16 6LA
Tel: 0845 602 4285
Fax: 01934823899
9
1
2
3
13mm, 10mm, 8mm
4
5.5mm
5
6
7