Filter
Top Products
31
Stardance Direct Vent/Natural Vent Gas Heater
20007065
FC107
SIT820
valve conversion
10/03
A
B
C
O
F
F
P
I
L
O
T
O
Fig. 55 Remove mounting screws, pressure regulator tower
and spring and diaphragm assembly.
FC107
D
E
F
FC108
SIT
regulator
conversion
10/03
O
F
F
P
I
L
O
T
O
FC108
Fig. 56 Replace regulator.
Pilot Orifice Conversion
1. Locate pilot. (Fig. 53)
2. Replace pilot orifice.
Pilot Type 1
• Remove pilot hood by lifting up. (Fig. 57) Do not
remove snap ring to remove pilot hood. NOTE: It is
not necessary to remove the pilot tube for conver-
sion.
• Remove pilot orifice with Allen wrench. (Fig. 58)
• Install the conversion orifice.
• Reinstall pilot hood. Be sure to align hood with
index tab.
CO105a
gas conversion
Pilot
1/28/00 djt
Pilot Hood
Pilot
Bracket
CO105a
Fig. 57 Remove pilot hood.
CO106a
DV360/580
Gas Conversion
Pilot2
1/28/00 djt
Index Tab
Snap Ring
CO106a
Fig. 58 Remove pilot orifice.
Allen Wrench
Pilot type 2
• Loosen pilot hood turning counterclockwise using a
7/16” wrench. (Fig. 59) NOTE: You may use pen-
etrating oil to prevent pilot hood threads from seizing
up.
• Remove pilot orifice with needlenose pliers. (Fig.
60) NOTE: Use a wrench to hold pilot tube in place
while removing the orifice.
• Install the conversion orifice.
• Reinstall pilot hood and tighten until mark on pilot
hood aligns with mark on pilot bracket.
NOTE: Be sure burner leg remains at a 90° angle to
firebox base after conversion.
CO105
Gas Conversion
Pilot
2/15/99 djt
Pilot
Index
Marks
Pilot Bracket
CO105
Fig. 59 Remove pilot hood. (Your pilot may have a different
appearance.)
CO106a
Gas Con
version
Pilot (Vermont)
7/19/99 djt
Pilot Orfice
CO106b
Fig. 60 Remove pilot orifice.