Filter
Top Products
7
10005898
Vermont Castings, Majestic Products, DEF33/36, DEFD33/36
Installation of DEF33 Logs
Refer to Figure 4.
1. Turn off power to the unit.
2. Remove front glass (See "Glass Removal" section),
or open front doors.
3. Remove logs from packaging.
4. The ember lava rock is shipped in place; no
adjustment is necessary.
5. Fit the log right (A37) onto plate log support. Ensure
the bottom holes of the log are located on the two
pins of the support.
6. Fit the log left (A38) onto plate log support. Ensure
the bottom holes of the log are located on the two
pins of the support.
7. Place the log center (A39) on ember lava rock. Use
the notches under the log center to properly locate
the log. The top of this log sets on the log right.
8. Place the log left top (A40) in position by resting
the hole under the center of this log over the knob
on the log left, and the front of log sets on the log
center and against the back wall of plate log
support.
1005694
Fig. 4 DEF33/DEFD33 Logset
Installation of DEF36 Logs
(B116)
(B115)
(B119)
(B118)
MVC_002F
Fig. 5 DEF36/DEFD36 Logset
Refer to Figure 5.
1. Turn off power to the unit.
2. Remove front glass (See "Glass Removal" section),
or open front doors.
3. Remove logs from packaging.
4. The ember lava rock is shipped in place; no
adjustment is necessary.
5. Place the center log (B117) on the ember lava rock.
Use the notches under the log center to have a
proper location.
6. Place the right log (B115) onto the plate log support.
Ensure the bottom of the log sets against the side
wall of plate log support, and the top of the log sets
on the log center.
7. Place the left log (B116) onto the plate log support.
Ensure the side of the log sets against the side wall
of plate log support and the back of the log sets
against the tinted light screen.
8. Place the crossover left log (B119) in position by
resting the top of the log on the log left. The other
end of the log sets against the back wall of the plate
log support.
9. Place the crossover right log (B118) in position by
resting the top of the log on the log right. The other
end of the log sets against the back wall of the plate
log support.
A40
A39
A37
A38
(B117)