Filter
Top Products
1414
10005898
Vermont Castings, Majestic Products, DEF33/36, DEFD33/36
CAUTION: Remove all plastic from brass trims.
Do not remove existing frame window assembly.
1. Remove existing bottom louvre and hinges from
fireplace, if the fireplace has been installed with
louvres. (Set aside the four [4] screws).
2. Remove existing top louvre from fireplace by lifting
up and pulling out, if the fireplace has been installed
with louvres. If the fireplace was installed with the
Radiant face, move to step 3.
3. Hang Bay Window unit over existing glass frame.
4. Reinstall upper louvre assembly.
5. Bottom brass trim is removable when fireplace is
installed with marble or tile surround which covers
the fireplace bottom.
Louvre Face Installation
1. Remove the top radiant face by removing the two
screws securing it in position; one screw is located
on each side of the top radiant face at the bottom
front.
2. Remove the deflector cabinet top from the top
radiant face. (Save the screws and deflector cabinet
top to reinstall into the top Radiant panel.)
3. Open the access Radiant face door, then remove
the bottom radiant face by removing three (3) screws
securing it in position. One screw is located on each
side of, and at the center of, the bottom radiant face
at the top front.
4. Reinstall the deflector cabinet top fasteners in the
pre-punched screw holes in the bottom of the
fireplace cabinet top.
5. Install bracket louvre top fasteners into the
prepunched screw holes in the cabinet bottom.
6. Install hinge fasteners in the prepunched screw
holes at the front of the fireplace cabinet base.
7. Install the bottom louvre by aligning the prepunched
hinge holes with the pre-punched louvre bracket
holes; fasten securely with screws
8. Install the top louvre by pushing it down into the slot
of the bracket louvre; refer to step 5.
Louvre Removal
To remove top louvre, pull the louvre up and then lift
it out (Fig. 9).
1.
2.
Louvre
Glass Panel
FP444
Fig. 9 Remove louvre assembly.
Bay Window Installation