Filter
Top Products
12
BLADE PREPARATION AND INSTALLATION
Blade Irons (5) Blade Medallions (5)
Blades (5)
Screw Pack C
Blade Screws (21)
Screw Pack D
Blade Iron Screws (11)
Step 4a.
the blade badge onto the blade (Pack C), then attaching
the bladeholder using the four blade screws provided
as shown in Figure #1. Using the provided screwdriver,
tighten securely by hand only. Repeat for each blade
assembly.
Step 4b. Attach each blade/bladeholder assembly to
the motor by threading two blade iron screws (Pack
D) through the matching holes in the blade iron and
the motor as shown in Figure #2. Using the Phillips
blade assemblies have been installed, tighten the
screws with the screwdriver as shown in Figure #3.
BLADE HARDWARE (not to scale)
Blade Screws
Blade Iron
Blade Badge
Motor
Blade Iron
and Blade
Figure #1
Figure #2
Figure #3