Filter
Top Products
5
Dutchwest Natural Vent Gas Heater
30002008
Clearance Requirements
Minimum Clearances to
Combustible Materials
Measure side clearances as shown in Figures 2
through 5 from the outer edge of the cast iron stove top.
Measure rear clearances from the outermost surface of
the sheet metal rear skirt.
The Dutchwest heater is approved for installation into
an alcove constructed of combustible materials to the
dimensions and clearances shown in Figure 5.
The same clearances apply in a standard parallel instal
-
lation.
Hearth Requirements
The Dutchwest Heater must be installed on rigid floor-
ing. When the heater is installed directly on any com-
bustible surface other than wood flooring, a metal or
wood panel extending the full width and depth of the
unit must be used as the hearth. There are no other
hearth requirements.
WARNING:
• Always maintain required clearances
(air spaces) to nearby combustibles
to prevent fire hazard. Do not fill air
spaces with insulation. All venting compo-
nents must maintain a 1” (25 mm) clearance to
combustible materials. Maintain a 6” (152 mm)
clearance when using single wall pipe.
• The gas appliance and vent system must be
vented directly to the outside of the building
and never be attached to a chimney serving a
separate solid fuel or gas-burning appliance.
• Refer to the manufacturer’s instructions in
-
cluded with the venting system for complete
installation procedures.
Ceiling Clearances
ST774
Fig. 4 Minimum ceiling clearance; minimum alcove height.
72"
(1829mm)
ST774
Dutchwest
nv
Min. Clg Clrnc
6/03 djt
45"
(1140mm)
Parallel Installation: Minimum Clearance
and Flue Centerline
Stove Clearances A: 5” (125mm)
B: 4” (102mm)
Pipe Centerlines C: 16” (406mm)
D: 9¹⁄₄” (235mm)
ST128c
Fig. 2 Parallel installation requirements.
ST128b
Stardance
flue centerline
9/28/00 djt
C
L
C
L
B
D
C
A
Corner Installation: Minimum Clearance and
Flue Centerline
Stove Clearance A: 4” (102mm)
Pipe Centerline B: 17” (432mm)
ST129c
Fig. 3 Corner installation requirements.
ST129c
Dutchwest
corner specs
5/15/03 djt
A
A
B
B
Alcove Minimum Dimensions
A: 4” (102mm) B: 33” (838mm) C: 5” (125mm)
ST775
Fig. 5 The Dutchwest Natural Vent Stove is approved for
installation into alcoves built of combustible materials.
ST658
SNV
alcove mins.
5/25/01 djt
B
A
A
C