Filter
Top Products
16
R
TEST PROGRAM
LIGHT OPERATION
FAN OPERATION
The light is turned on and off by alternate pushes of the
large left hand button. When on, the display will indicate
the light bulb symbol and a vertical segment display repre-
senting brightness. When the light is on, the brightness may
be changed by using the small and buttons below the
light button. Pressing and holding either button will change
the brightness continuously.
Bulb-Saver Feature
When the light is turned on, the brightness is gradually in-
creased until it reaches the preset level. This feature helps
extend light bulb life.
ADDITIONAL CONTROL FEATURES
Additional control program features are available from the con-
trol panel by opening the control panel door. To activate a control
function press the appropriate button; the display will indicate
that the program is running.
In some cases you can run more than one program at once, such
as and and the display will indicate that they are
both activated. In other cases one program will override another
as the two programs can not run together i.e. and .
Full details are explained in the sections that follow.
Labeling: If you have more than
one Comfort•Touch fan in your
home, we suggest you put an ad-
hesive room identification label
on the back of the control. La-
bels are in the remote control
package.
General: Your Comfort•Touch remote control uses one of 15
different radio signals to control the fan. This channel is set at
the factory. There may be times when the channel needs to be
changed,i.e.:
• Two fans in the house set to the same causing interference.
• Two fans are to be operated from one control.
• Two controls are to operate the same fan - see special 'Dual
Remote Control' section on the next page.
IMPORTANT OPERATING NOTES
Press the button to activate a two minute program
that puts the fan through a complete functional test. The
test starts with a full screen display, then the 'preset' chan-
nel number before going into a full light, fan and reverse
exercise. Follow the remote control LCD display and com-
pare it to the actual fan operation to confirm correct
operation.
The Comfort•Touch fan is controlled by the remote control.
The fan is turned on and off by alternate pushes of the large
right hand button. As with all button operations, an audio
tone sounds with each push. With the fan on, the control
display will indicate an up or down moving arrow that shows
direction and places a box around the operating speed. The
two small and buttons below the fan button increase
or decrease speed once for each press.
Turning On Your Fan: The fan will not receive any signals
for the first 20 seconds after power on. This allows the
electronics to warm up and stabilize.
Power Failure: The remote control is not affected by house-
hold power failure as it is battery operated. Once power is
restored to the fan it will receive an auto-update signal from
the remote control within 30 minutes after power is restored.
All previously set modes and functions will be restored to
the fan.
Button Operation: Rapid button pressing causes erratic
fan operation. For reliable operation of the remote control
and fan you must wait ONE SECOND between button presses
to allow the radio signal to be transmitted to the fan and
received.
CONTROL
PANEL
CONTROL PANEL
DOOR
W-21
TEMPERATURE
TEST
BUTTON
FULL LCD
SCREEN
DISPLAY
FAN
ON/OFF
BUTTON
SPEED
UP/DOWN
BUTTONS
AIRFLOW
DIRECTION
FAN SPEED
LIGHT
UP/DOWN
BUTTONS
LIGHT
ON/OFF
BUTTON
BRIGHTNESS
INDICATOR
SPACE FOR LABEL
R