Filter
Top Products
5
ADAPTOR PLATE INSTALLATION
JOIST
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
GREEN
GROUND
WIRE
CEILING FAN
APPROVED
WIRING BOX
RIDGE
SIDE
DOWN
APPROVED
OUTLET BOX
HARDWARE
Note: After removing the old fixture, check the outlet box
to insure that it is supported by a joist or beam across its
upper surface. If not, a 2" x 4" stud must be installed.
Step 1. Remove the knockout plug in the center of the outlet
box or drill a
1
/2" hole for the lag screw to pass through. Then
drill a
1
/4" guide hole into the joist or beam to a depth of 3".
CAUTION: To reduce the risk of personal injury,
use only the mounting hardware provided with
the approved outlet box to install the crossbar
mounting bracket.
CEILING HARDWARE
CROSSBAR
MOUNTING
BRACKET
WIRE NUT (4)
ADDITIONAL HARDWARE
2
1
/4" x 8-32 ROUNDED
HEAD SCREW (2)
FLAT WASHER (2)
1" x 8-32 ROUNDED
HEAD SCREW (2)
SUPPORT INSTALLATION PARTS
CANOPY
ADAPTOR
PLATE
LAG SCREW
3
/
8
" #7 X 5" (1)
LARGE
FLAT WASHER
3
/
8
" (1)
WARNING!
SUPPORT DIRECTLY TO
BUILDING STRUCTURE ONLY.
19
th
Century
™