Filter
Top Products
11
GLASS & BULB INSTALLATION
GLASS SHADE
SCREWS
Step 18. Loosen the three glass screws for each
fixture so the end of the screws are flush with
the inside of the fixture.
Slide the glass shade into the fixture and hold
firmly. Turn each screw several times, going in
a circle, to assure that all glass screws have en-
gaged the glass.
Tighten securely by hand only.
Step 19. Install the four 60 Watt type A15 bulbs
into each fixture.
GLASS SHADE
GLASS HARDWARE
60 WATT TYPE A15
INCANDESCENT BULB
GLASS SHADE
Note: Do NOT use standard (A-19) bulbs. This
commonly available size is too large in diameter; the
proximity of the bulb to the glass will not allow for
adequate air circulation.
CAUTION: TO REDUCE THE RISK OF FIRE
USE MAX FOUR 60W STANDARD BASE
A15 INCANDESCENT LIGHT BULBS
60 WATT TYPE A15
INCANDESCENT BULB
19
th
Century
™
OPTIONAL SWICH HOUSING CUP
NOTE: This step is ONLY performed if
you have chosen NOT to install the light
kit.
Slide the optional switch housing cup over
the threaded pipe from the switch hous-
ing. Assure that no wires are pinched.
Secure the cup to the fan with the finial.
Tighten securely by hand only.
FINIAL
THREADED
PIPE
OPTIONAL SWITCH
HOUSING CUP