New Buck Corporation 34 Indoor Fireplace User Manual


 
SECTION IV
INSTALLATION OF MODEL 34 (WS)
OPTIONAL WOODEN SURROUND (KIT#PAKDFP34)
NOTE: See page 26, figure 6 for clearances.
(1) When choosing the right location for your heater and surround (mantel) keep the
following in mind:
NOTE: Due to high temperatures, this heater should be located out of traffic
areas and away from furniture and draperies.
CAUTION: THE INSTALLATION MUST CONFORM TO LOCAL CODES. IN THE
ABSENCE OF LOCAL CODES, INSTALLATION MUST CONFORM WITH
THE NATIONAL GAS CODES.
NOTE: See Section II for gas hookup and pressure check.
NOTE: See “Producing Adequate Ventilation” page 35.
WARNING: CHILDREN AND ADULTS SHOULD BE ALERTED TO THE
HAZARDS OF HIGH SURFACE TEMPERATURES AND SHOULD STAY AWAY TO
AVOID BURNS OR CLOTHING IGNITION. YOUNG CHILDREN SHOULD BE
CAREFULLY SUPERVISED WHEN THEY ARE IN THE SAME ROOM WITH THE
APPLIANCE
WARNING: DO NOT PLACE CLOTHING OR OTHER FLAMMABLE
MATERIAL ON OR NEAR THE APPLIANCE.
(2) Position screen before leaving heater unattended.
(3) Instructions for assembly of Wooden Surround (Mantel):
TOOLS NEEDED: Medium Phillips screwdriver, tape measure, power drill, and 5/16" socket.
STEP 1: Lay out all components.
STEP 2: Assemble end panels A & B to top front rail C.
STEP 3: Stand end panels and top front rail onto hearth.
NOTE: (Position back of end panels with back of hearth centering assembly
from each end). Install front screws first, then pull back towards the inside to
square the mantel. Install screws through back holes.
STEP 4: The owner must decide at this time if parts D, E, and F are to be wood or green.
Beginning with panel E stand chosen color face out on hearth flush against stop block located
inside end panel A and attach. Position the left end of top window D on top of E and attach.
Slide panel F under the right end of D and attach.
STEP 5: Take metal trim panel provided with surround (mantel) and position it on top of
heater. Measure 11 1/8" from back of stove, center panel and attach with self-tapping screws
provided.
STEP 6: Place a cloth or blanket over the front portions of surround (mantel) as not to scar the
wooden part of the surround.
28