WARNING: ELECTRICAL GROUNDING INSTRUCTION: THIS HEATER IS
EQUIPPED WITH A THREE-PRONG PLUG FOR YOUR PROTECTION AGAINST
SHOCK HAZARD AND SHOULD BE PLUGGED DIRECTLY INTO A PROPERLY
GROUNDED THREE-PRONG RECEPTACLE.
NOTE: #PESBRO84 Blower may be used with Model FP-42-ZC.
Rating: 120 volts/60HZ/1.1 Amps.
See Figure 17, page 34 for
wiring diagram.
NOTE: For convenience, allow licensed electrician to install properly grounded
3-plug receptacle near unit.
ROOM BLOWER INSTALLATION AND OPERATION INSTRUCTIONS
The room air blower is located at the rear of the unit in the bottom chamber. To remove or replace
the blower, open lower louvered access door. The motor is located right center in rear. Remove the
two (2) hex head screws holding the motor and motor bracket to the outer bottom of the unit. Unhook
the two motor wires and remove the motor from the unit. Next remove the two (2) screws that fasten
the motor bracket to the motor. Locate the motor bracket on the new motor in the same position as
with the old. Using the two (2) hex head screws fasten the bracket to the new motor. Place new
motor into the lower compartment. NOTE: Make sure the motor opening 1" x 5" is behind the
inner wall of the stove and not touching any metal. Fasten the new motor and bracket to the motor
support on the bottom of the unit. Hook the motor wires as shown in the diagram on page 24.
Installation and repairs should be performed by a qualified service person. The appliance should be
inspected before use and at least annually by a professional service person. More frequent cleaning may
be required due to excessive lint from carpeting, bedding material, etc. It is imperative that control
compartments, burners and circulating air passageways of the appliance be kept clean.
25