Filter
Top Products
21
Prepare the bridge for enrollment.
Unplug Ethernet and power cables from bridge.a.
Verify that blue light is blinking. If blue light is solid, battery is dead.b.
Install a quality 9 volt battery.c.
Take bridge to the location where the thermostat is mounted.d.
Enroll Thermostat into Schlage LiNK
TM
System
22
Enroll the thermostat into the bridge.
If you are using a controller that is not a Schlage LiNK
TM
bridge,
consult the instructions that came with the controller to fi nd out how
to enroll a new device.
Hold the bridge within 6 feet (1.8 meters) of the thermostat a.
throughout all of step 2.
Important Note: After you begin the enrollment process, you have
30 seconds to complete the remainder of the steps. Study the steps
below before beginning.
Press and release the plus (+) button on the bridge.b.
Press the c. MENU button on the thermostat.
Scroll down to d. Z Wave Install, and press the Select button.
Press the e. Yes button to enroll the thermostat.
Observe the lights on the bridge. The orange light will blink f.
while enrollment is taking place. Enrollment is complete
when the orange light becomes solid.
MENU button
MENU MODE FAN RUN
75
76 H
74 C
11:15 AM Outside 60
Gateway
MENU MODE FAN RUN
75
76 H
74 C
11:15 AM Outside 60
Done
Select
Menu Selection
User Settings
Usage Graph
ESM Setpoints
ZWave Install
Select button
Scroll
down
23
Verify enrollment of the thermostat.
Press the a. MENU button on the thermostat.
Scroll down to b. Thermostat Info, and press the Select button.
Look at the number listed after c. ZNID.
If the number listed there is anything other than “000”, the thermostat
has been successfully enrolled.
If the number listed there is “000”, the thermostat has NOT been
successfully enrolled. In this case, repeat step 22 and verify again.
Press Done button when fi nished.
10
ZNID
Done
Thermostat Info
TZEMT400AB32 Ver: 01.00.10
ZVER:02.00.0 ZNID: 013
ZHID: 01.07.37.a7
System Type: Standard
Fan Type: Gas