Filter
Top Products
78
APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Error messages
When erroneous operations are performed messages and advice on operation will be displayed on the LCD.
Follow what is displayed. If you press or do the operation correctly while the error message is
displayed, the message disappears.
Error Message Probable Cause
There is a possibility that the data for the selected pattern is corrupted.
The start/stop button was pressed at a screen other than the embroidery
screen.
Upper thread broken.
Upper thread not set up correctly.
Upper thread has run out.
CAUTION
Be sure to rethread the machine. If you press (Start/stop button)
without rethreading the machine, the thread tension may be wrong or
the needle may break and cause injury.
The machine is deleting a previously saved pattern.
on the LCD was pressed when no card was inserted.
The start/stop button or thread cutter button was pressed while the
embroidery foot was raised.
The memory is full and the pattern cannot be saved.
You pressed the back key or the embroidery key while a pattern was
selected.
You tried to select an embroidery pattern or change the layout when
the needle was down.
The machine is turned on while the needle is lowered.
F-combo-BrotherE_sgml.book Page 78 Thursday, November 17, 2005 3:39 PM