Filter
Top Products
82
APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Error messages
When erroneous operations are performed messages and advice on operation will be displayed on the
LCD. Follow what is displayed. If you press or do the operation correctly while the error
message is displayed, the message disappears.
No
Error Message Probable Cause
1 There is a possibility that the data for the selected pattern is corrupted.
2
The start/stop button was pressed at a screen other than the embroidery
screen.
3
Upper thread broken.
Upper thread not set up correctly.
Upper thread has run out.
CAUTION
Be sure to rethread the machine. If you press (Start/stop button)
without rethreading the machine, the thread tension may be wrong or
the needle may break and cause injury.
4
The machine is deleting a previously saved pattern while in embroidery
edit mode.
5
While embroidering, data is written to the “Removable Disk” in the
connected computer or data is deleted from the “Removable Disk”.
6
on the LCD was pressed when no card was inserted.
7
The start/stop button or thread cutter button was pressed while the
embroidery foot was raised.
8 The memory is full and the pattern cannot be saved.
appendix1 Page 82 Monday, August 18, 2008 8:08 PM