Filter
Top Products
74
APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Care and Maintenance
Simple machine maintenance operations are described below.
Cleaning the machine surface
If the surface of the machine is dirty, lightly soak a
cloth in neutral detergent, squeeze it out firmly, and
then wipe the surface of the machine. After cleaning
it once with a damp cloth, wipe it again with a dry
cloth.
CAUTION
Cleaning the race
Embroidery performance will suffer if dust collects in
the bobbin case. Therefore, it should be cleaned
periodically.
a
Turn off the machine.
b
Unplug the power supply cord from the power
supply jack on the right side of the machine.
CAUTION
c
Remove the embroidery unit.
d
Loosen the needle clamp screw and remove
the needle (page 28).
a Screwdriver
b Needle clamp screw
e
Grasp both sides of the needle plate cover, and
then slide it toward you.
a Needle plate cover
X The needle plate cover is removed.
f
Remove the bobbin case.
Grasp the bobbin case, and then pull it out.
a Bobbin case
● Unplug the power supply cord before
cleaning the machine. Otherwise, injuries
or an electric shock may occur.
● Unplug the power supply cord before
cleaning the machine. Otherwise, injuries
or an electric shock may occur.
a
b
a
a
appendix1 Page 74 Monday, August 18, 2008 8:08 PM