Filter
Top Products
11
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Needle and embroidery foot
section
a Thread guide disk (page 40)
Pass the thread through the thread guide disk when
using the needle threader to thread the needle.
b Needle bar thread guide (page 40)
Pass the upper thread through the needle bar thread
guide.
c Needle plate
When the needle is lowered, it enters the hole in the
needle plate.
d Needle plate cover (page 74)
Remove the needle plate cover to clean the bobbin case
and race.
e Bobbin cover/bobbin case (page 35)
Remove the bobbin cover, and then insert the bobbin
into the bobbin case.
f Embroidery foot “Q” (page 76)
This presser foot is used for embroidering.
Right-side/rear view
a Handle
Carry the machine by its handle when transporting the
machine.
b Handwheel (page 38)
Turn the handwheel toward you (counterclockwise) to
raise and lower the needle.
c Embroidery card slot (page 55)
Insert the embroidery card.
d USB port (page 71)
Connect the one end of the USB cable to this port and
the other to the computer.
e Air vent
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the machine
is being used.
f Main power switch (page 18)
Use the main power switch to turn the machine on and
off.
g Power supply jack (page 18)
Insert the plug on the power supply cord into the power
supply jack.
Memo
z Refer to pages 10 through 13 while you are
learning to use your machine.
0711-0120-C-combo_E.book Page 11 Thursday, July 24, 2008 1:46 PM