Filter
Top Products
Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
Installation Instructions TDB3104, WF3204
Bradley Corporation • 215-1470 Rev. H; EN 06-915
172/8/07
Figure 12
SPRAYHEAD
TUBING
NUT
MALE
TUBE
CONNECTOR
TUBING
Installation Instructions continued . . .
NOTE: Flush supply lines before making connections.
4. Follow the procedures below and refer to Figure 12 when installing tubing to ensure that you
achieve a leakproof seal. Install 3/8" supply tubing in the sprayhead using the male tube con-
nector.
• Using a sharp razor, cut tubing squarely and remove any burrs. DO NOT pinch or crush end
of tubing.
• Loosen nut on fitting. Moisten end of tube and push into fitting until it is firmly seated.
Tighten nut to secure tube to fitting (make sure nut is securely tightened).
• If connector leaks, reseat tubing according to above procedure. If leaking persists,
replace male connector, or call your Bradley representative for assistance.