Filter
Top Products
Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
TDB3104, WF3204 Installation Instructions
Bradley Corporation • 215-1470 Rev. H; EN 06-915
12 2/8/07
Installation Instructions continued . . .
4. Place the actuator module assembly on top of sprayhead. Rotate until actuator module locks in
with tie bar. Drop two 1/8" diameter tubes down to valve assembly and connect to the air valve.
NOTE: Skip to number 5 for units without soap.
• For units with soap option, install the spacer, soap dispenser and cover using the third tie rod
(8-5/8" long) and second coupling nut as shown (see Figure 8). Secure with acorn nut and set
screw.
5. Secure actuator module cover and top cover with sprayhead restraining bracket, acorn nut and
set screw.
6. FOR A UNIT: Connect supply lines to stops using suitable fittings.
FOR O UNIT: Install 1/2" nominal copper tubing supply lines (pass them through holes in
cover down through support column) and connect to stops using suitable fittings.
Sprayhead troubleshooting. Adjust volume control valve, if necessary, to control water flow.
Figure 8
TOP COVER
SPRAYHEAD
S05-054B
SUPPORT TUBE
(STD.) S57-005
(TAS)(JUV.) S57-006
MODULE
COVER
COUPLING NUT
SPACER
ACTUATOR
MODULE
ASSEMBLY
S65-134
SOAP
DISPENSER
TIE ROD
21-5/8" (STD.)
18-1/8" (JUV.)
TIE BAR
UNIT WITH “O” DRAIN AND ACTUATOR MODULE
SHOWN, ALSO AVAILABLE WITH “A” DRAIN
COUPLING
NUT
8-5/8"
TIE ROD
4-1/4"
TIE ROD